WANTED
I need a used Deep V hull and drive equipment to get running all I have is
a motor and radio gear. ( I Race 1/8 on road and want to play with a boat)
nothing
less than 48 or so inches, any deep v or mono.
Dan Dobogai
920-923-3631 Kart14@hotmail.com Fond du
Lac WI
WANTED: I have an aero tec tunnel that I need The installation sheet and hardware for. I have not been able to locate aero tec or anyone that has ran the boat. If anyone can point me in right direction to a contact, I would appreciate it. thanks again, Can some one tell me how to get in touch with the person that made this boat?
International Hobbies outboards and any parts you may have. There was a lot of these at one time. So look in your parts boxes and closets. Please contact me at
I would like to purchase a competitive 60 Hydro or possibly a very good .45 Hydro preferably less than 2-years old. Please contact Rich Henderson at rich_henderson_98@yahoo.com Thank you.
I am looking for parts for the K&B 3.5 Outboard. E-mail me to let me know what you have.
WANTED: Plans for weed powered outrigger and Tunnel Hull design. Also would like to buy or trade for other 1/4 Scale plans for wood boats. Contact Bill LaRue
WANTED: 55" White Dumas Scarab Hull. Contact Lou
WANTED: 60 scale hydro hull. I have totaled a PICO American Spirit and have the engine and radio but need a raceable hull cheap! If you have one you need to get out of your workshop please contact me! slsova@aol.com
WANTED: I'm looking for any plans (prints) for a 7.5 cc powered out-rigger hydro. I am planning to build one out of fiberglass sheeting instead of wood (should be stronger and lighter) and don't feel like buying a kit just for the plans. I'll pay any postage required, make copies and send originals back. Contact Brad
WANTED: I'm looking for a ROADRUNNER .90 twin in excellent condition. Contact Gill
WANTED: I need information on parts for the McCullough Titan engine. I need a piston ring and cylinder base gasket. There aren't any dealers in my area and would appreciate any information on where to get these parts. Thanks! Contact Jamie Hankins